Since I tend to be a DIYer with my hobbies, I thought about building my own background/backdrop support system for portrait photography. After much research, I decided against it. I'm not handy with electric tools and overall it would have been a lot of work.
My brother sent me a link to Cowboy Studios. I looked around and saw some pretty good support systems. I knew the main bars that holds the fabric had to be strong. I've read where other manufacturer's mid section would sag under the weight of the muslin or paper. I decided on their 10 foot Premium Heavy Duty System (901). I searched my favorite site and was able to apply my rewards points. Another great deal.
Way before purchasing this support system, I had already purchased the fabric. I was at my local G-Street Fabric store and rummaging through their clearance tables when I found this wonderful fabric:
The fabric is not close to being white, but for my use it will do for now.
Here's the Cowboy Premium Heavy Duty (901) Support System:
![]() |
Here's where the top bar sits on top of one of the adjustable stands:
The two top bars connected (slide one bar into the other and turn 90 degrees):
The logo on one of the stand's leg:
One of the sturdy stand legs:
The storage bag. The two outer pockets hold the two stands and the inner holds the 4 support bars:
The bag zipped up and ready to go:
My temporary studio setup with fabric draped over the bar (only have two support bars put together):
For the first few sample pictures I've taken with a fairly wide open aperture, the creases and wrinkles from the fabric don't show. I will have to invest in a portable steamer later.
I went with a portable system as I do not have the space to setup a permanent studio. Setup of this portable background system doesn't take too long to install or take down. Basically, I setup and open the two stands and adjust for height. I take two, three or all four bars and connect them. I move my stands apart to fit the length of two, three, or four bar widths. I lift the bar and place it on top of the stands. I place and screw down the wing nuts on the pole/stand. That's it!



























